mFlipLock panic security multi-point locking system 24576PBa-SV

Overview of Advantages

• Monitoring and feedback of the lock status 3 flip latches with sound insulation
• Mechanical automatic locking
• Easy to open under pre-load
• Version with round cylinder or profile cylinder
• Backset: 30 - 80mm
• square face plate in 20 or 24 mm width, U-shaped face plate in 24 mm width
• No
• Certification according to EN 1125
• Certification according to EN 1634-1 to 3
• Intrusion resistance up to Class RC3 achievable in suitable door systems

Product description

• These multi-point locks are equipped with monitoring contacts. (Monitoring control latch status, door handle status, bolt status and cylinder status). A door handle is also mounted on the outside of the door. In unlocked state, the door can be opened from both sides. In locked state, the door can not be opened from the outside, but can always be opened from the inside via the door handle, panic door fitting or pushbar (panic function). The 3 long bolts are retracted and the 3 flip latches are released at the same time. The lock locks automatically when the door closes (automatic locking). The spindle (follower) is split with panic function B. This panic function is suitable for doors that also have to be opened from the outside at specific times (daytime operation). Daytime operation can be activated via the cylinder, with a key turned in the direction of opening to the stop - the door handle is then engaged on the outside of the door. Only available in combination with a panic inactive leaf locking system. This enables the door to be opened at all times, even if the lock on the active leaf is locked (panic function), via the panic fitting or pushbar. Automatic locking when the door is closed via switch lock triggering.

Area of Application

• For access control and monitoring in building management
• Security doors, escape route and fire doors in commercial and public buildings
• Internal building area in combination with access components

Note

• Suitable for freewheeling cylinders
• Backset 45/50/65 mm only on request.
• Round rosettes (cross-screwed) only from backset 45 mm.
• Use special profile half spindle MSL 5968
• Only for system partners with a training certificate
• External bolt switch contacts not permitted