Panic security mortise lock with contacts and panic function B, outwards opening 14576PBa-SV

Overview of Advantages

• Monitoring and feedback of the lock status
• Flip latch with sound insulation
• Mechanical automatic locking
• Easy to open under pre-load
• Version with round cylinder or profile cylinder
• Backset: 30 - 80mm
• Round face plate in 18mm / 20mm width or square face plate 24mm
• No
• Certification according to EN 1125
• Certification according to EN 1634-1 to 3
• Burglary resistant to class RC2 can be achieved in appropriate door systems

Product description

• These mortise locks are equipped with monitoring contacts. (Monitoring control latch status, door handle status, bolt status and cylinder status). A door handle is also mounted on the outside of the door. In unlocked state, the door can be opened from both sides. In locked state, the door can not be opened from the outside, but can always be opened from the inside via the door handle, (panic function inwards opening), the long bolt is retracted and the flip latch is released at the same time. The lock locks automatically when the door closes (automatic locking). The spindle (follower) is split with panic function B. This panic function is suitable for doors that also have to be opened from the outside at specific times (daytime operation). Daytime operation can be activated via the cylinder, with a key turned in the direction of opening to the stop - the door handle is then engaged on the outside of the door.

Area of Application

• For access control and monitoring in building management:
• Security doors, escape route and fire doors in commercial and public buildings
• Internal building area in combination with access components

Note

• Suitable for freewheeling cylinders, not suitable for external bolt switch contacts. For the U-shaped version, the accessory shim B-14421 is required. The backset 45/50/65 is only available on request.
• Round rosettes (cross-screwed) only from backset 45 mm.
• Connecting cable check must be ordered separately.
• Use special profile half spindle MSL 5968
• Only for system partners with a training certificate