sFlipLock e-drive, handle-operated 16546PBe-SV.3

Overview of Advantages

• Electronically engaging door handle
• Attached motor unit with integrated motor control for the basic open/close function With switched output if the lock has undergone motorised release.
• Display of the open position and feedback to electric door drives.
• Opening signal (GND) e.g. via fingerprint, button, switching timer, etc.
• Motorised opening in 1.5 seconds
• Switching between fail locked / fail unlocked via DIP switch
• No
• Approved in accordance with EN 1634-1 to 3 with AWS
• Approved in accordance with EN 12209 Class 7
• Approved in accordance with EN 18251-2 Class 5
• Burglary resistant to class RC2 can be achieved in appropriate door systems

Product description

• The sFlipLock e-drive handle-operated mortise lock is equipped with a split handle follower so that the inside handle is engaged and the outside handle is not engaged. A fitting with a door handle is typically mounted on both sides of the door. Exit through the locked door is possible at any time via the inside door handle contact handle. This pulls the long bolt back and also unlocks the flip latch (panic function, inwards opening). When unlocking from outside via an electronic impulse, fingerprint, button, badge or timer switch, the outside handle is engaged and the dead bolt is retracted to 5 mm first. The fliplatch is then released by the door handle and the lock is completely released. Emergency opening from the outside is possible at all times via the cylinder when the door is locked. The lock locks automatically again when the door closes (automatic locking)

Area of Application

• Internal building areas, office rooms, IT server rooms, industrial areas and public buildings
• Security doors, escape route and fire doors in commercial and public buildings

Note

• Suitable for freewheeling cylinders, not suitable for external bolt switch contacts. For the U-shaped version, the accessory shim B-15544 is required. Backset 45/50/65 on request. Connecting cable and striking plates must be ordered separately.
• Round rosettes (cross-screwed) only from backset 45 mm.
• Use special profile half spindle MSL 5968